EasyManuals Logo

H3C SecPath F5030 User Manual

H3C SecPath F5030
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
2
Symbol Description
Transported and stored avoiding humidity, rains and wet floor.
Electrical safety
Carefully examine your work area for possible hazards such as moist floors, ungrounded power
extension cables, and missing safety grounds.
Locate the emergency power-off switch in the room before installation. Shut the power off at
once in case accident occurs.
Do not work alone when the firewall has power.
Always verify that the power has been disconnected.
Laser safety
WARNING!
Disconnected optical fibers or transceiver modules might emit invisible laser light. Do not stare into
beams or view directly with optical instruments when the switch is operating.
The firewall is a Class 1 laser device.
Before you disconnect the fiber connector, execute the
shutdown command in interface view
to disable the optical source.
Install dust caps to disconnected optical fiber connectors and ports on disconnected transceiver
modules to avoid damage caused by built-up dust.
Insert a dust plug into empty fiber ports.
Handling safety
When you move the firewall, follow these guidelines:
Move and unpack the firewall carefully to avoid firewall damage.
Unpack the firewall at least half an hour and power on the firewall at least two hours after you
move it from a place below 0°C (32°F) to the equipment room. This prevents condensation and
even damage to the firewall.
Use a safety hand truck when you move multiple firewalls.
Before you move the firewall, remove all cables and mounting brackets.
For long-distance transportation, remove all the field-replaceable units (FRUs), such as power
modules and interface modules, and package them separately, and install the filler panels
supplied with the firewall. For short-distance transportation, make sure all the FRUs are
securely seated in the slots and the screws are fastened.
When you move or lift the firewall chassis, support the bottom of the chassis, rather than
holding any FRU.
Make sure the accessories of the firewall are not lost or damaged during firewall moving.

Table of Contents

Other manuals for H3C SecPath F5030

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the H3C SecPath F5030 and is the answer not in the manual?

H3C SecPath F5030 Specifications

General IconGeneral
BrandH3C
ModelSecPath F5030
CategoryFirewall
LanguageEnglish

Related product manuals