Hach 2100AN - Page 68

68
SECTION 6, continued
A. Baud Rate Select:
1. Press
SETUP (the small LED mode display flashes).
2. Use the up, down and right arrow keys to enter
10 into the mode display.
3. Press
ENTER.
4. The current baud rate flashes in the large display (1200 is the factory setting).
5. Use the up or down arrow keys to select the desired baud rate.
6. To store, press
ENTER.
7. Press
SETUP to exit the setup mode.
B. Character Length Select:
1. Press
SETUP (the small LED mode display flashes).
2. Use the up, down and right arrow keys to enter
11 into the small display.
3. Press
ENTER.
4. The current character length flashes in the large display.
5. Use the up or down keys to select the desired character length.
6. To store, press
ENTER.
7. Press
SETUP to exit the setup mode.
C. Stop Bit Select:
1. Press
SETUP (the small LED mode display flashes).
2. Use the up, down and right arrow keys to enter
12 into the mode display.
3. Press
ENTER.
4. The current number of stop bits flashes in the large display.
5. Use the up or down keys to select the desired stop bits.
6. To store, press
ENTER.
7. Press
SETUP to exit the setup mode.
D. Parity Select:
1. Press
SETUP (the small LED mode display flashes).
2. Use the up, down and right arrow keys to enter
13 into the mode display.
3. Press
ENTER.
4. The current parity selection flashes in the large display.
5. Use the up or down arrow keys to select the desired parity.