75
SECTION 7 INSTRUMENT CLOCK
7.1 Clock Description
The 2100AN Instrument contains a battery-backed, real-time clock. This feature
provides a time-date stamp on all data transmitted to the internal printer or to
external devices via the RS232 Interface. Time and dated measurements,
calibration records, instrument setup data and diagnostic records are recorded
and maintained easily using this feature.
7.2 Setting Hours and Minutes
1. Enter the setup mode by pressing SETUP. The mode display will flash.
2. Select the number
05 using the up, down and right arrow (edit) keys, then
press
ENTER.
3. Set the hours and minutes (
HH-MM) using the edit keys (24 hour format).
Press
ENTER to accept the new setting.
4. Press
SETUP to exit the setup mode. Pressing UNITS/EXIT at any time, prior to
accepting the new value, exits the setup mode leaving original values intact.
7.3 Setting the Month and Day
1. Enter the setup mode by pressing SETUP. The mode display will flash.
2. Select the number
06 using the edit keys followed by ENTER. Set the month and
day (
MM-DD) using the edit keys.
3. Press
ENTER to accept the new setting.
4. Press
SETUP to exit the setup mode. Pressing UNITS/EXIT at any time, prior to
accepting the new value, exits the setup mode leaving original values intact.
7.4 Setting the Year
1. Enter the setup mode by pressing SETUP. The mode display will flash.
2. Select the number
07 using the edit keys followed by ENTER.
3. Set the year (
YY) using the edit keys. Press ENTER to accept the new setting.
4. Press
SETUP to exit the setup mode. Pressing UNITS/EXIT at any time, prior to
accepting the new value, exits the setup mode leaving original values intact.
7.5 Displaying Current Time
1. Enter the setup mode by pressing SETUP. The mode display will flash.
2. Select the number
08 using the edit keys, then press ENTER. The current time
is displayed (
HH-MM-SS).
3. Press
ENTER to display the time. Press SETUP to exit.
To Next Page
Loading...
