SECTION 6, continued
67
6.2 RS232 Connection
The RS232 connection on the back panel mates with a standard RS232 connector
as indicated in Figure 17 (also see Table 3 and Figure 18). The factory RS232
interface output is an eight-bit data word plus one stop bit and no parity with a
baud rate of 1200. These settings can be changed with the setup menu, and are
saved in non-volatile memory.
Figure 17 DB-9 Male RS232 Connector
Figure 18 RS232 Connection
Table 3 RS232 Pin Connections
Pin Description
2 - RXD Receive Data
3-TXD TransmitData
5 - GND Signal Ground
6-DSR*
* Pin 6 is an optional printer handshake line. Do not connect when using a computer.
Data Set Ready
SHELL - FG Frame Ground
All other pins are not connected
AIR PURGE
RECORDER
REMOTE
20 PSIG MAX
WARNING:
FOR CONTINUED PROTECTION AGAINST FIRE
HAZARD, REPLACE ONLY WITHTHE SAME TYPE
AND RATING OF FUSE
WARNING:
ADVERTISSEMENT:
WHEN PANEL IS REMOVE, EYE PROTECTION IS REQUIRED AND EXPOSED SURFACES
MAY CAUSE SEVERE BURNS.
LORSQUE LE PANNEAU EST RETIRE LE PORT DE LUNETTES DE PROTECTION
EST INDESPENSABLE ET LES SURFACES EXPOSEES PEUVENT CAUSER DE BRULEURES GRAVES.
AVERTISSEMENT: POUR UNE PROTECTION
CONTINUE CONTRE LE FEU REMPLACER LA
FUSIBLE PAR UNE DU MEMETYPE ET DE MEMES
CHARACTERISTIQUES
SERIAL I/O
T,1.6A, 250V
RS232 Connection
To Next Page
Loading...
