Hach 2100AN - Page 88

88
SECTION 10, continued
9. The left digit flashes. Use the edit (Arrow) keys to change the displayed
number to
0.3180.PressENTER to accept 0.3180 as the point 2 value (NTU)
10. The large display shows
0.0000 MGL with the decimal point flashing. Press
the Right Arrow key once to move the flashing decimal point one position to
the right. Press
ENTER to accept the decimal point location. The left digit
begins flashing. Use the Arrow keys to change the displayed number to
10.000.PressENTER to accept 10.000 as the point 2 MGL value.
11. The mode display flashes
03 to indicate that point 3 is shown in the large LED
display. The blank spaces in front of the NTU units (
----- NTU) indicate no
value is assigned to point 3.
12. Press the Right Arrow key to initiate editing of point 3. The large LED display
shows
0.0000 with the decimal flashing. Press ENTER to accept the decimal
point location. The left digit flashes. Use the edit keys to change the displayed
number to
0.5420.PressENTER to accept 0.5420 as the point 3 value (NTU).
13. The large display shows
0.0000 MGL with the decimal point flashing. Press
the Right Arrow key once to move the flashing decimal point one position to
the right. Press
ENTER to accept the decimal point location. The left digit
begins flashing. Use the edit keys to change the displayed number to
20.000.
Press
ENTER to accept 20.000 as the point 3 MGL value.
14. The mode display flashes
04 to indicate that point 4 is shown in the large LED
display. The blank spaces in front of the NTU units (
----- NTU) indicate no
value is assigned to point 4.
15. Press the right arrow key to initiate editing of point 4. The large LED display
shows
0.0000 with the decimal flashing. Press ENTER to accept the decimal
point location. The left digit flashes. Use the edit (Arrow) keys to change the
displayed number to
0.6630.PressENTER to accept 0.6630 as the point 4 value
(NTU).
16. The large display shows
0.0000 MGL with the decimal point flashing. Press
the right arrow key once to move the flashing decimal point one position to
the right. Press
ENTER to accept the decimal point location. The left digit
begins flashing. Use the edit (Arrow) keys to change the displayed number to
30.000.PressENTER to accept 30.000 as the point 4 MGL value.
17. The mode display flashes
05 to indicate that point 5 is shown in the large LED
display. The blank spaces in front of the NTU units (
----- NTU) indicate no
value is assigned to point 5.
18. Press the right arrow key to initiate editing of point 5. The large LED display
shows
0.0000 with the decimal flashing. Press ENTER to accept the decimal
point location. The left digit flashes. Use the edit keys to change the displayed
number to
0.7090.PressENTER to accept 0.7090 as the point 5 value (NTU).
19. The large display shows
0.0000 MGL with the decimal point flashing. Press
the right arrow key once to move the flashing decimal point one position to
the right. Press
ENTER to accept the decimal point location. The left digit
begins flashing. Use the edit keys to change the displayed number to
40.000.
Press
ENTER to accept 40.000 as the point 5 MGL value.