EasyManua.ls Logo

Hach DR/2010 - Using the 1-CM Cell Adapter

Hach DR/2010
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
28
2.5.5 Using the 1-cm Cell Adapter
Use standard 1-cm square cuvettes with the DR/2010 Spectrophotometer
when Hach's 1-cm adapter (optional accessory) is installed. Glass 1-
centimeter cuvettes are not supplied with the instrument, but are optional
accessories in optically matched pairs. Quartz 1-cm cells are not
necessary for the instrument because the spectrophotometer does not
measure in the UV range (but they will work well if used).
Figure 8 Installing the 1-cm Cell Adapter
Place the adapter in the instrument cell compartment with the handling
tab to the rear (see Figure 8). This orients the adapter correctly in the light
path. When using glass cuvettes, place them in the adapter with the clear
sides in the right-to-left optical path. Close the cell compartment cover

Table of Contents

Related product manuals