Hach DR/2010 - Printing Current Measurement Data; Printing Stored Data; Printing Single Stored Data Points; Printing All Data Stored in One Group

53
3.7.1 Printing Current Measurement Data
To print data that is displayed after a measurement, press
SHIFT PRINT.The
display will show
PRINTING.....and then return to the normal
measurement display. The printed information is sent in an 80-column
format (see Figure 13).
Figure 13
Printed Data Format Example
*Denotes that a warning occurred during reading or the wavelength used was not the wavelength in the program
3.7.2 Printing Stored Data
To print stored data, you must display the data, then print it. To display the
data, use the Recall menu (see 3.6, Recalling Data).
3.7.2.1 Printing Single Stored Data Points
When the data for the desired group and sample number are displayed,
press
SHIFT PRINT. The display will show (i.e., G100 is the group number
assigned; #3 is the sample number):
Press
ENTER. The display will show PRINTING. . . . . andthenreturntothe
units and parameter.
If the data is stored only in Group 0, the display will only show the sample
number. The rest of the printing sequence is the same.
3.7.2.2 Printing All Data Stored in One Group
1. To print all the data in one group, press
SHIFT PRINT after the group and
sample number is displayed. Then press the
DOWN ARROW. The display
will show:
25-JUN-96 13:45:23 *1.245 mg/L An. Surfact 575nm DR/2010 P710 SN:789456123
25-JUN-96 14:03:11 -0.05 Abs 300.2 %T 575nm DR/2010 P710 SN:789456123
26-JUN-96 07:12:46 7.95 mg/L NO
2
-
HR *593nm DR/2010 P373 SN:789456123
nm
+8.8.:8.8. ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ
888540
*0.16 Print G100 #3
nm
+8.8.:8.8. ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ
888540
*0.16 Print Grouð 100