Hach DR/2010 - Recalling Data

51
1. After pressing
STORE, the display shows (X is the group number
assigned; Y is the next available sample number within that group):
SAMPLE #Y
or
GX SAMPLE #Y
2. Press ENTER or STORE to accept the sample number. To enter another
sample number, use the
ARROW keys to scroll to the desired number or
enter the desired number with the
NUMERIC keys. Press ENTER or STORE
to accept the desired number. The instrument will store the data, then
revert back to the measurement display.
If the desired storage number is known, enter the number with the
NUMERIC keys, then press STORE (pressing ENTER is not necessary).
3. To change the group number before storing a displayed data point go
to the Setup menu by pressing the
EXIT key once. Press SHIFT SETUP to
enter the Setup menu. Use the
ARROW keys to scroll down to the Group
option (Auto Group must be OFF). Press
ENTER. Enter the correct
group number with the
NUMERIC keys or scroll to it using the ARROW
keys. Press ENTER. Press the EXIT keytoreturntotheStore menu.
3.6 Recalling Data
1. To recall data stored in the DR/2010 Spectrophotometer, press
SHIFT
RECALL
. If the data is stored only in Group 0, the display will show
data for the last sample of the last program used (for example):
nm
+8.8.:8.8. ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ
888540
*0.14 Samðle #1
nm
+8.8.:8.8. ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ
888540
*0.28 G100 Samðle #2
nm
+8.8.:8.8. ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ
888540
*0.16 mç/L Cr