Hach DR/2010 - Creating a User Program

62
3.10 Creating A User Program
At any point during the following procedure, the operator can terminate
entering the calibration, and exit by pressing
EXIT. The display will show:
Press
ENTER to store the program. Press EXIT to exit without storing the
entered data.
1. Turn the instrument on with the
I/O key.
After the self-test the display will show:
2. Select the Lamp: Constant On mode in the Setup menu. Return to the
Enter Program prompt by pressing
EXIT.
3. Press
SHIFT USER PRGM to go to the Create Program menu.
The display will show:
4. Press
ENTER. The display will show:
5. Press
ENTER. The program number will flash. The instrument
automatically displays the next available program. If the number
displayed by the instrument is desired, press
ENTER.Youmayalso
enter the desired program number between 951 and 999 number using
the
NUMERIC keys.
nm
+8.8.:8.8. ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ
888500
* Store Chançes?
nm
+8.8.:8.8. ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ
888500
* Enter Proçram #
nm
+8.8.:8.8. ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ
888500
* Create Proçram
nm
+8.8.:8.8. ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ
888500
* New Prçm:951