63
6. Press
ENTER. The display will show:
(The number 952 is used as an example here; the actual program
number displayed is the lowest, unassigned number between 950 and
999 available at the time).
Press
ENTER. Then press the DOWN ARROW key.
The display will prompt for the program name (16 character
maximum):
There are two techniques for constructing the name:
a) Selecting characters by entering appropriate numeric codes with
the keypad (see “Constructing a Display Using Numeric Codes”
on page 65). Press
ENTER after each character is selected.
b) Scrolling through the character menu with the arrow keys. Press
SHIFT twice to capitalize letters, subscript or superscript numbers.
Press
ENTER after desired character is displayed. When the cursor is
flashing, press
ENTER again to accept the character string (see
“Constructing a Display By Scrolling on page 67).
To enter a program name press
ENTER. The display will be blank
except for a cursor. Enter the characters using the instructions
given in “Constructing a Display Using Numeric Codes” on
page 65 or “Constructing a Display By Scrolling” on page 67.
When the complete name is entered, press
ENTER.
7. Press the
DOWN ARROW to go to the next option. The display will show:
The flashing Decimal prompt is asking for the appropriate
measurement resolution for this test.
nm
+8.8.:8.8.
ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ
888500
*
New Prçm:952
nm
+8.8.:8.8.
ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ
888500
*
Proçram Name:
nm
+8.8.:8.8.
ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ
888500
*
Decimal: 0.000
To Next Page
Loading...
