64
8. Press
ENTER so the decimal point flashes. Set the decimal point
position using the arrow keys. Press
ENTER. The Decimal prompt will
flash again. Press the
DOWN ARROW key to go to the next selection.
9. The display gives the next prompt:
10. To change the units, press
ENTER so that (None) is flashing. Use the
ARROW keys to select one of the available units of measure. The menu
includes:
mg/L, µg/L, ng/L, ppm, ppb, ppt, g/kg, mg/kg, oz/gal, lb/ac,
kg/ha,%, g/gal, mg/100g, mg%, units, ftu, mol/L, mmol/L,
and meq/L.
Note: The first display in the units menu is blank (NONE). If the desired unit is
not included above, selection of the blank reserves all sixteen character spaces
for input at the next (SYMBOL) prompt; a custom unit can then be constructed
along with the symbol describing the method.
11. When the appropriate units selection appears, press ENTER.
12. Press the
DOWN ARROW to go to the next selection.
The display then prompts:
13. Press
ENTER. The display will show the selected units followed by a
flashing cursor. In the remaining spaces after the semicolon, add
various characters to construct a chemical symbol or otherwise
describe the method.
There are two techniques for constructing the symbol:
a) Selecting characters by entering appropriate numeric codes with
the keypad (see “Constructing a Display Using Numeric Codes”
on page 65). Press
ENTER after each character is selected.
b) Scrolling through the character menu with the
ARROW keys
(see “Constructing a Display By Scrolling” on page 67). Press
SHIFT twice to capitalize letters, subscript or superscript numbers.
Press
ENTER after the desired character is displayed. Press ENTER
again to accept the character string. Continue to Step 14 on
page 68.
nm
+8.8.:8.8.
ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ
888500
*
Units: (None)
nm
+8.8.:8.8.
ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ
888500
*
Sùmbol:
To Next Page
Loading...
