40
1. Press:
I/O. Wait for the self-test to finish.
2. Press:
SHIFT SETUP.
The first menu option is Auto Group. If Auto Group is ON, it will
automatically assign stored samples to a group number that is the
same as the program number. For example, the data for a reactive
phosphorus Test ’N Tube test will be stored in group 535 because the
program number in the DR/2010 is #535. Sample numbers may be
assigned automatically or by the operator in the Store Menu.
To change the OFF-ON status of Auto Group, press
ENTER (otherwise
press the
DOWN ARROW). Use the ARROW keys to toggle between Off and
On. Press
ENTER when the desired status is displayed.
Press the
DOWN ARROW to advance to the next option (options in step 3
are not shown if Auto Group is ON).
I/O Options Submenu:
Baud:
9600 is default. Other choices: 4800, 2400, 1200, 600, 300
Bits
: Default is 8; other choice is 7
Parity
: None is default; Other choices: Even, Odd
Date:xx-Sep-96 Set day-month (alpha)-year (in that order); For example 06-Aug-96
Time: xx:xx:xx Set hours-minutes-seconds (in that order). For example 23:30:21.
Beeper Options Submenu:
Key Beep:
Default is On; Other choice: Off
Error Beep:
Default is On; Other choice: Off
Alert Beep:
Default is On; Other choice: Off
Signal Average Default is Off; Other choice: On
Lang Default is English; Other choices: Japanese, Dutch, Spanish,
Portuguese, French, and German
Adjust Contrast Arrow keys increase or decrease contrast; 10 choices possible.
Auto Off Selects number of minutes between last key press and automatic
shutoff when in the momentary lamp mode.
Program Update Use this menu when updating Hach programs or entering new
Hach programs.
Adjust nm Calibrates the optics in the instrument.
Peak filter: Lets user determine the peak transmittance using the
808 nm filter.
Default Setup: DR/2010 Spectrophotometer will use factory
wavelength calibration with no adjustment.
Service Menu For Hach Service personnel only.
Table 5 Setup Menu Message Guide (Continued)
Message Selections
To Next Page
Loading...
