Hach DR/2010 - Page 69

69
17. Press the
DOWN ARROW. If any information was entered for Alternate
Form2, the display will show:
Enter an Alternate Form3 if desired or press the
DOWN ARROW.The
display will show:
Note: The low
limit reminds
stored program
users when
displayed values
are below the
working range of
the test.
18. To change the low limit of the procedure range, press ENTER (if not,
press the
DOWN ARROW). Use the NUMERIC keys to enter the low range
limit. Press
ENTER to accept the displayed number.
19. Press the
DOWN ARROW key. The display will show:
Note: The high
limit reminds
stored program
users when
displayed values
are above the
working range of
the test.
20. To change the high limit of the procedure range, press ENTER (if not,
press the
DOWN ARROW).Usethenumerickeystoenterthedesiredhigh
range limit. Press
ENTER to accept the displayed number.
21. Press the
DOWN ARROW. The display will show:
22. Press
ENTER. Enter the desired wavelength using the NUMERIC keys. The
wavelength must be between 400 to 900 nm. Press
ENTER when the
desired wavelength is displayed.
nm
+8.8.:8.8. ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ
888500
* Alternate Form3:
nm
+8.8.:8.8. ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ
888500
* Low Limit:0.000
nm
+8.8.:8.8. ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ
888500
* Hiçh Limit:9.999
nm
+8.8.:8.8. ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ
888500
* Wavelençth:400nm