EasyManuals Logo

Hach LXV321.99.00001 User Manual

Hach LXV321.99.00001
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
27
Operation
5.2.1 Selecting the calibration curve
Before starting the measurement, the calibration curve that corresponds to the
measurement point must be selected.
1. Select
MENU, confirm with ENTER/ON.
2. Select
CALIBRATE, confirm with ENTER/ON.
3. Selectthe curve shown and confirm with
ENTER/ON.
4. Select the desired curve with the navigation key
UP/DOWN and confirm with
ENTER/ON.
5. Select
CLEAR/OFF twice to return to the main menu.
5.2.2 Start the measurement
When starting the measurement, the measurement is carried out continuously and the
current measurement value is saved at intervals.
1. Select
MEASURE, confirm with ENTER/ON.
2. Select
START and confirm with ENTER/ON.
5.2.3 Interrupt and resume the measurement
1. Press CLEAR/OFF for 2 seconds.
The instrument is switched off and the measurement is interrupted.
2. Press ENTER/ON for 2 seconds.
The instrument switches on and the measurement continues with the same settings
as before the instrument was switched off.
5.2.4 Stop measurement
1. Select MEASURE, confirm with ENTER/ON.
2. Select
STOP, confirm with ENTER/ON.
5.3 Show the data in the display
The display shows the stored data for the corresponding calibration curves.
1. Select the desired calibration curve (refer to section 5.2.1, page 27).
2. Select
DATA, confirm with ENTER/ON.
3. Select
DISPLAY DATA and confirm with ENTER/ON.
Only the stored data for the selected calibration curve is displayed.
5.4 Delete data for a calibration curve
1. Select the desired calibration curve (refer to section 5.2.1, page 27).
2. Select
DATA, confirm with ENTER/ON.
3. Select
DELETE MEP and confirm with ENTER/ON.
Only the stored data for the selected calibration curve is deleted.
4. Select YES, confirm with ENTER/ON.
Note: NO aborts the erasing procedure.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hach LXV321.99.00001 and is the answer not in the manual?

Hach LXV321.99.00001 Specifications

General IconGeneral
BrandHach
ModelLXV321.99.00001
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals