49
Installation
4.4.5 Reagents installation
1. Prepare the reagents according to Reagent Preparation on page 137. Install the reagent
canisters in their place and connect them to their respective tubes.
2. Install and connect the conditioning solution (diisopropylamine). The diagrams show an
analyzer for non-cationic applications. Analyzers for cationic applications have a small pump
installed above and to the left of the reagent canisters.
3. Install and connect the reactivation
solution (blue R label).
4. Install and connect the auto calibration
solution (yellow CAL label).
To Next Page
Loading...
