51
Installation
4.4.7 Reagents volume declaration
Note: As you will now be using the analyzer menus to input data, it may be useful to familiarize yourself with
the data entry procedures by reading the section entitled Data entry on page 59 of this manual.
1. Open the sample valve and check that there is no leakage in the hydraulic path.
2. Power on the analyzer.
3. Select the Menu option from the display.
4. Select MAINTENANCE/DIAG. from the main menu
and press Enter
5. Select the REAGENT CHANGES option and press
Enter
6. Set the BOTTLES FULL parameter to Yes and
press Enter.
7. Press Esc to return to the MAINTENANCE/DIAG.
menu.
To Next Page
Loading...
