Hach QC8500 Series 2 - Apply Power to the Pump; Pump Tubing Installation

18
Installation
3.2.2 Apply power to the pump
To apply power to the pump:
1. Turn on the power strip, then turn on the power switch on the back of the pump
(Figure 14). In an RP-150 Model pump, the top panel will show the set speed of 35.
3.2.3 Pump tubing installation
To install the pump tubing:
1. Remove all of the pump cartridges. Press the cartridge holder against the pump, then
lift the cartridges out (Figure 15).
Figure 14 Power switch location
1 Power switch
Figure 15 Pump cartridge removal
1 Cartridge 2 Cartridge holder