5
Section 1 Specifications
Specifications are subject to change without notice.
1.1 Bench requirements
Ideally, the modules are configured in the following left-to-right order: computer (with
peripherals), sampler, PDS200 Dilutor, reagent pump and system unit (refer to Figure 1).
Note: The sampler and dilutor can be placed on top of the optional shelf accessory in order to
conserve bench space.
The bench space required for a QuikChem
®
FIA System with up to five channels, dilutor,
sampler, computer and printer is:
• Width: 2.72 m (9 ft)
• Depth: 0.83 m (2.75 ft)
• Height: 0.58 m (2 ft)
Figure 1 QuikChem FIA overview
1 Autosampler 5 Computer and peripherals
2 Dilutor (in rear) 6 Power cords
3 Pump 7 Communication cables
4 System unit
To Next Page
Loading...
