EasyManua.ls Logo

Hach Sigma 900 MAX - Power Connections

Hach Sigma 900 MAX
122 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
41
Installation
4.9 Power connections
Danger
Electrocution Hazard. If the sampler is installed outdoors or in any wet or
potentially wet location, a Ground Fault Circuit Interrupter (GFCI) is required. If the
sampler is installed outdoors, over-voltage protection is required.
Note: Install the sampler on its own circuit to ensure a continuous, stable source of power.
Important Note: This product is not intended for use with a split-phase (3-wire,
single-phase, mid-point neutral) AC power system. Use this product only with a 3-wire
(Hot/Neutral/Ground) polarized AC power system. Be sure that access to the power cord
plug is not blocked or obstructed. The AWRS sampler is not provided with a power switch.
The cord plug serves as the local disconnect.
Figure 20 Full bottle shut off installation
1 Inside tube fitting 5 Slot
2 Retainer pin 6 Full bottle shut-off assembly
3 Tubing support 7 Threaded hole
4 Thumbscrew
Goodnal STP ST041 Pre Treatment (Sigma 900 MAX All Weather Refrigerated Sampler) Vendor Manual
Q-Pulse Id VM373
Active 29/10/2013
Page 41 of 122

Table of Contents

Related product manuals