Hach SP-510 - Startup; Start the instrument; Calibration; Complete a 2-point calibration

18
SECTION 2, continued
2.3 Wall Mounting the Instrument
The instrument case is designed for wall mounting. Refer to Figure 2, Figure 3,and
Figure 4 for dimensions and other installation information. Use ¼-inch screws for
mounting. Mount the instrument as close to the sampling point as practical to ensure
complete purging of the sample line each cycle. Leave adequate clearance at the
sides and bottom of the instrument case for plumbing and wiring connections.
Figure 2 SP-510 Instrument Dimensions (1 of 3)