Hach SP-510 - Cleaning the Instrument Enclosure; Replacing the Sample Conditioning Filter; Reagent Spill Clean up Instructions

SECTION 5, continued
47
5.2.3 Cleaning the Instrument Enclosure
With the enclosure securely latched, use a soft cloth and a mild detergent to wipe
the outside of the enclosure. Do not allow moisture to enter the enclosure.
5.2.4 Replacing the Sample Conditioning Filter
To insert the filter into the housing:
1. Unscrew the top of the filter housing. See Figure 7 on page 25.
2. Insert the filter element and push until it stays in place.
3. Replace the filter housing top.
5.2.5 Reagent Spill Clean Up Instructions
Wipe up spills with a clean, disposable wipe and discard according to applicable
Federal, State and Local regulations.