Describing the MCS+ Control Panel 3-3
P/N 85213-30, Manual revision: B
UPPER CONTROL PANEL
The upper section of the MCS+ control panel will provide the operator with visual
information concerning the status of the donor and donor blood flow, as well
updated procedure statistics throughout the entire MCS+ collection protocol.
Donor flow
indicator lights
There is a set of flow indicator lights located on the top of the MCS+ control
panel, above the display screen. These lights provide the same information about
donor/patient blood flow status during the apheresis procedure as the other sets
of flow indicator lights located on the MCS+ cabinet side panels.
The lights are arranged as follows:
Figure 3-2, MCS+ control panel flow indicator lights (text version)
Note: The design of the fourth set of flow indicator lights, located on the exterior
of the MCS+ cabinet cover, is identical to those located on the control panel. All
of the lights provide the same information simultaneously throughout the MCS+
procedure.
Display screen The MCS+ screen will display different types of information to the operator
throughout a collection protocol. All MCS+ protocols will use the same screen
layouts and provide the operator with the same types of information on the
display screen. This information will concern:
! MCS+ self-testing protocol option selection.
! Disposable set installation.
! Procedure parameter modification.
! Haemo Calculator and Haemo Update information.
! MCS+ anticoagulant priming sequence.
! MCS+ operating mode and sub state.
! NOTICE messages and related HELP messages.
Note: Protocol-specific screen data will be explained in each MCS+ protocol
manual.
DRAW
1. Green
2. Yellow
3. Red
RETURN
4. Yellow
3. 4.2.1.
To Next Page
Loading...
Need help?
General
