Describing the MCS+ Disposable Collection Material 4-7
P/N 85213-30, Manual revision: B
AC line section This section of the disposable tubing will deliver AC solution to the section of
tubing containing donor whole blood. The elements found on the AC line section
can vary according to the selected disposable set.
Anticoagulant spike
This element permits the operator to attach the AC solution bag to the disposable
set.
Note: Haemonetics recommends spiking the AC solution bag prior to hanging it
on the solution pole, to avoid any possible AC solution drops on the device. AC
solution becomes “sticky” as it dries and can become difficult to properly clean.
Anticoagulant drip chamber
A drip chamber for the AC solution is present on the “closed” MCS+ disposable
sets. It is also available on certain bundled and unbundled harness-in sections.
Bacterial filter
This element can be found on a “closed” set. The 0.22 µm filter can eliminate
bacteria from entering the system, due to spiking the AC solution bag.
Single-pump manifold and tubing
This element will secure the AC tubing as it is autoloaded on the AC pump, as
well as during MCS+ operation.
AC pump “stops” and tubing
These elements, found on disposable sets which do not utilize the Transfer pump,
will secure the pump tubing in preparation for pump autoloading.
Note: Pump tubing can be easily distinguished because it is more elastic. This
elasticity helps to reduce twists and occlusions when the tubing is thread around
the pump rotors.
Single-pump manifold adapter
The adapter will provide a means to secure tubing containing AC pump “stops”
onto the MCS+ single-pump housing, during autoload and operation of the AC
pump.
To Next Page
Loading...
Need help?
General
