Safety instructions
2 Safety instructions
Electrical devices must only be installed and assembled by a qualified electrician in accordance
with the relevant installation standards, guidelines, regulations, directives, safety and accident
prevention directives of the country.
Failure to comply with these installation instructions may result in damage to the device, fire or
other hazards.
Before any maintenance, repair or handling work is performed at the device connections, the
device must be disconnected from all power sources, including the device's own power supply
and the measuring equipment.
If an anomaly or a malfunction is identified, the device must not perform any measurements.
Contact customer service if you find the device is not functioning correctly.
Hager accepts no liability for damage caused by improper handling or by non-observance of
warning information and recommendations.
6 Fehlerstromschutz-Relais
To Next Page
Loading...
