18
Starting Up
2.3.3 Adjusting the driver's seat
The driver's seat (Fig. 8) must be ad-
justed so that the driver is seated com-
fortably and can reach all the operating
elements with ease.
The vehicle is equipped with a
seat contact switch. The vehi-
cle can only be operated when
the op
erating person is seated
on the seat.
The Hakomatic B1050 is equipped with
a driver's seat which can be adjusted in
a longitudinal direction (forward and
back):
• Press the lever on the right of the
se
at outwards slightly
• then slide the seat forward or back in
steps of 15 mm.
Fig. 8
2.4 Before starting up daily
Carry out the following checks before
sta
rting the vehicle up for its daily oper-
ation (also refer to Section 5.3.2):
1. Check the recovery tank, empty as
necessary. Clean it as necessary.
Refer to Sections 5.6.1 and 5.6.2.
2. Fill the solution tank and cleaning
ag
ent in accordance with the manu-
facturer's mixing directives. Refer to
Section 3.1.4 and Section 5.5.1.
Only use cleaning agents (non-
foaming) suitable for the vehi-
cle's vendor. We recommend
using our clean and care prod-
ucts which are specially bal-
anced for the vehicles. These
prod
ucts meet the require-
ments stipulated in the wash-
ing and cleaning agent direc-
tive (WRMG - Wasch- und
Rei
nigungsmittelgesetzes).
3. Check the battery charge and re-
charge as necessary; refer to Sec-
tion 5.4.1.
Before starting the vehicle for
its first working operation, carry
out an ini
tial battery charging
routine; refer to Section 2.2.
4. Check the parking space for signs of
leaks. Hoses, lines and tanks must
show no signs of leaks or damage. If
necessary, clear up any defects be-
fore putting the vehicle into opera-
tion.
To Next Page
Loading...
