HAKO Hakomatic B1050 - Maintenance and Care; Hako System Maintenance

53
Maintenance and Care
5 Maintenance and Care
General information
Before proceeding with main-
tenance and care work you are
advi
sed to read and comply
with the Safety Information
chapter!
Compliance with the recommended
main
tenance works will give you the
certitude of always having a reliable
machine at disposition.
Daily or weekly maintenance and repair
work may be executed by the driver/op-
erator having been trained accordingly.
Further Hako system maintenance
works have to be executed by qualified
personnel only. Please contact your lo-
cal Hako Service Centre or Hako con-
tract dealer. We cannot be held liable
for damages resulting from non-compli-
ance with these instructions.
Please indicate the machine's serial
number with any enquiry or spare part
order, see paragraph 1.7, Rating plate.
5.1 Hako System Maintenance
The Hako System Maintenance:
• guarantees reliable operability of the
Hako machin
es (preventive mainte-
nance)
• minimizes operating costs, repair
costs an
d maintenance costs
• ensures long service life and opera-
bility of the machine
The Hako System Maintenance is
structured in separate modules and de-
termines specific technical work to be
executed as well as the intervals for
such maintenance work. For any specif-
ic maintenance type, the replacement
parts are determined and listed in spare
part kits.
Hako System Maintenance Cus-
tomer:
To be performed by the customer in ac-
cordan
ce to the maintenance and care
instructions contained in the operating
instructions (daily or weekly). The driv-
er/operator will be instructed upon de-
livery of the machine.
Hako System Maintenance I :
(every 250 hours of operation)
T
o be performed by qualified personnel
of authorised Hako Service Centre in
accordance with the machine-specific
system maintenance including spare
part kit.
Hako System Maintenance II:
(every 500 hours of operation)
T
o be performed by qualified personnel
of authorised Hako Service Centre in
accordance with the machine-specific
system maintenance including spare
part kit.
Hako System Maintenance III/S:
(every 1000 hours of operation safety
check)
T
o be performed by qualified personnel
of authorised Hako Service Centre in
accordance with the machine-specific
system maintenance including spare
part kit. Execution of all safety-relevant
inspections according to UVV-BGV-
TÜV-VDE as prescribed by law.