60
Maintenance and Care
5.3.3 Hako system maintenance II The following maintenance work must
be completed by an authorized Hako
service center.
Activity
Interval
Every 500 operating hours
Complete all activities in Hako system maintenance I, see paragraph 5.3.2 o
In addition:
Check the output of the hydraulic motor (forwards, reverse); clear defects as necessary o
Change the hydraulic motor carbon brushes o
Check the brush motor output (left and right); clear defects as necessary o
Change the brush motor carbon brushes o
Check the side brush drive; clear defects as necessary o
Change the side brush drive carbon brushes o
Including visual inspection, test drive, test report, inspection label and logbook
see paragraph 5.3.2
o
To Next Page
Loading...
