Service Manual
Hako GmbH Technical Service (KUD) 23843 Bad Oldesloe Edition: 05/2014
Confidential - For internal use only!
Terminate configuration mode by pressing the left button. Display then shows charge state.
After setting make sure to separate connection of plug contact in the dashboard.
Setting parameter:
4 x 6 V / 240 Ah GiV mainten.-free
24V / 420Ah EPzS low-mainten.
In the display, three digits for the
value are flashing (set to
1.73 V/Z in the factory).
Press the right button “►“ to increment the discharged value by 0.01 V/Z or hold depressed
for continued incrementing.
After the charged value has been attained, display re-starts automatically with 1.50 V/Z.
After the desired discharged value of the profile has been attained, press the left
button”▲/•“ once.
73
To Next Page
Loading...
