PIANO / ENSEMBLE Voice Sections64
From the screen shown at the bottom of the previous page, press the DIRECTION “q” button once.
The box to the right of “REL VEL TRK” should be highlighted.
RELEASE RATE VELOCITY TRACK
This Parameter allows you to adjust the Release Rate of the Filter EG by key velocity. You can select from 0
to 127. A higher velocity will result in a longer rate.
Turn the VALUE knob to the right to increase the Release Rate.
Turn the VALUE knob to the left to decrease the Release Rate.
NOTE: The Velocity Parameter in the COMBINATION Edit Menu must be “ON” (values 1 ~ 4) in order to hear
the effect of Velocity Tracking.
From the above screen, press the PAGE “u” button once. The AMPLITUDE Page should now display.
The box to the right of “VEL DEPTH” should be highlighted.
AMPLITUDE
VEL DEPTH
This Parameter allows you to adjust the amount of volume in response to key velocity. You can select
from 0 to +100%. At 0 there is no change in volume. At +100%, the volume is changed by the maximum
amount corresponding to velocity.
Turn the VALUE knob to the right to increase the Velocity Depth.
Turn the VALUE knob to the left to decrease the Velocity Depth.
To Next Page
Loading...
