If one of the options (V-Blank or Blank-V ) is selected in the View / Modify Method screen, the blank value will be active on the
View/Modify Method screen and the value of the blank can be set (in liters).
5.5.13. CALCULATIONS
The final result is calculated using the end point volume (titrant volume at the equivalence point or at the fixed end point), and a
formula selected by the user.
5.5.13.1. STANDARD TITRATION
5.5.13.1.1. EDIT VARIABLE VALUES
Edit the variables in a previously selected calculation.
For each formula, selected variables can be changed.
5.5.13.1.2. NO FORMULA (mL ONLY)
Only the volume of titrant (mL) required to reach the end point will be displayed.
5.5.13.1.3. NO FORMULA (L ONLY)
Only the volume of titrant (L) required to reach the end point is displayed.
To Next Page
Loading...
