21
SETUP
6.1.11. AUTO OFF
Option: OFF, 5, 10, 30 or 60 minutes
This option helps conserve power when the instrument is not being used. If there is
no interaction between the user and the instrument for the set amount of time, the
instrument will automatically turn off to preserve the battery.
If the auto off is set to OFF and the power adapter is removed, the meter will auto
off after 60 minutes unless the power adapter is reconnected.
Press the EDIT key to modify value.
Use the or key to select the desired value.
Press the CFM key to confirm the auto off or the CLR key to return to the setup menu
without saving.
6.1.12. FACTORY RESET
This option will reset the instrument to its factory settings.
Press the CFM key to perform the factory reset.
Press the YES key to continue or the NO key to return to the meter setup menu.
Note: Back up all data before you continue to prevent accidental data loss.
Once this process has been started, it cannot be interrupted or reversed.
The meter will restart when the factory restart is complete.
6.1.13. RESET CONFIGURATION
This option will reset all modifications made in the meter setup. All values will be
reset to default.
Press the CFM key to reset the configuration. Press the YES key to continue or the
NO key to return to the meter setup menu.
6.2. SYSTEM CHECK
Use the or key to select system check, press the to enter the
menu.
System check allows you to view information about the instrument and perform self
diagnostic tests.
6.1.10. CUVETTE DETECTION
Option: On or OFF
If this option is ON, automatic cuvette detection is enabled. If the wrong cuvette
is used an error message will be displayed.
If this option is OFF, the indicated cuvette must be used with the factory methods
to get a valid measurement.
To Next Page
Loading...
Need help?
General
