28
6.4.1. MEASUREMENT UNIT
Option: None, %T, ABS, ppm, mg/L, ppt, °f, °e, ppb, meq/L, µg/L, PCU, Pfund, pH, mV, dKH, °dH or meq/kg
This option allows you to select the measurement unit.
Press the EDIT key to select the measurement unit.
Use the or key to select the unit.
Press the CFM key to confirm the unit or the CLR key to return to the method settings
menu without saving.
6.4.2. NUMBER OF WAVELENGTHS
Option: 1 to 5
The option allows you to select the number of wavelengths used in the method
(Except for ABS or %T methods).
Press the EDIT key to change the number of wavelengths.
Use the or key to select the number of wavelengths.
Press the CFM key to confirm the number of wavelengths or the CLR key to return to the method settings menu without saving.
6.4.3. WAVELENGTH SETTING
Options: 340 to 900 nm
This options allows you to set the wavelength.
Press the EDIT key to modify the wavelength.
Use the or key to highlight the digit to be modified. Press the
or key to set the desired value.
Press the CFM key to confirm the set wavelength or the CLR key to return to the method settings menu without saving.
Note: Use the key to view additional wavelengths (if enabled).
6.4.4. DECIMALS
Option: 0 to 3
This option allows the user to set the measurement resolution (xxxx, xxx.x, xx.xx or x.xxx).
Resolution for absorbance (ABS) and transmittance (%T) are fixed and cannot be
modified.
Press the EDIT key to select the number of decimals.
Use the or key to select the number of decimals.
Press the CFM key to confirm the number of decimals or the CLR key to return to the method settings menu without saving.
SETUP
6.4. METHOD SETTINGS (USER METHODS ONLY)
Method Settings allows you to modify the settings and calibration curve for to the selected user method. These settings affect the
measurement.
To Next Page
Loading...
Need help?
General
