Source: You can use the trigger source options to select the signal that the oscilloscope
uses as a trigger.
CH1: Select CH1 as trigger signal
CH2: Select CH2 as trigger signal
Slope: Set the slope to Rising (+) or Falling (-).
Rising: Trigger on rising edge
Falling: Trigger on falling edge
3.5 Measure Signal
3.5.1 Cursor
Click “Cursor” in main menu.
This method allows you to take measurements by moving the cursors
1. Source
The user can set the source to CH1, CH2.
2. Type
There are four types of cursors: Cross, Vertical and Horizontal.
User’s Manual
33
Hantek 6022BL
To Next Page
Loading...
