5.7 Input Connector:
1
2
1. Button: press the button down to run hantek6022BL software.
2. Pins : connect peripheral equipment
5.8 The Measurement
The following figure shows the Measurement
1. Click the button of cursor, you can see the picture
z Time : the time of the two measurement line
z Frequency: the frequency of the two measurement line
z Transition : the transition of the two measurement line
z Cycles : the cycles of the two measurement line
2. Click on the mouse in the position of trying to start the measurement
3. Move the mouse to the position fo trying to end the measurement
User’s Manual
61
Hantek 6022BL
To Next Page
Loading...
