User Manual 57
Chapter 6 Sweep
In frequency sweep mode, the instrument moves from the start frequency to the stop frequency at
a specified sweep rate. You can sweep up or down in frequency with linea. You can also
configure the instrument to output one sweep from start frequency to stop frequency by applying
an external or manual trigger. The instrument can sweep sine, square, pulse, ramp, Harmonic or
arbitrary waveforms (DC are not allowed).
Select Frequency Sweep
Start Frequency and Stop Frequency
Center Frequency and Frequency Span
Linear sweep
Sweep Time
Return Time
Hold Time
Mark Frequency
Sweep Trigger Source
Trigger Output Edge
To Next Page
Loading...
Need help?
General