User Manual 79
IP Start: The start IP address of the HDG6000C hotspot.
IP End: The end IP address of the HDG6000C hotspot.
Subnet Mask: The subnet mask of the HDG6000C hotspot.
The format of IP Start, IP End and subnet mask is nnn.nnn.nnn.nnn. The nnn range is from 0 to
255.
Note: When any parameter is changed, the new parameter will take effect after press the confirm
softkey.
10.4 System Setting
10.4.1 Set the System Language
HDG6000B(C) supports menus in Chinese and English as well as provides corresponding help
information, prompt messages and interface display.
Press Utility -> System -> Language to select the desired language. When "中文" or "English" is
selected, the menus, help information, prompt messages and interfaces are displayed in Chinese
or English.
When you press “Default” to recall the default settings, the language will not be affected.
10.4.2 Power On Setting
Set the configuration to be used when the instrument is powered on the next time to "Default" or
"Last". The default setting is "Default".
Last: include all the system parameters and output configuration, except clock source.
Default: denote the factory default except some parameters (such as: Language).
Press Utility -> System -> Startup to select the desired configuration type.
When you press “Default” to recall the default settings, this setting will not be affected.
10.4.3 Sound
When the beeper in HDG6000B(C) is turned, the beeper sounds when users operate the front
panel.
Press Utility -> System -> Sound to select "On" or "Off" and the default is "Off".
10.4.4 Intensity
Press Utility -> System -> Intensity and use the knob to set the intensity of the screen.
The range is from 1% to 100%.
To Next Page
Loading...
Need help?
General