VINYL TOP COVER INSTALLATION INSTRUCTIONS
**Please read through all instructions prior to starting assembly of the top cover.
First, remove the screws and washers from the top of the 4 slide rods on the crib or bed.
Locate the plastic connectors, screws & nylon washers in the vinyl top cover assembly
hardware kit. Insert the screw into the connector as shown with the nylon washer.
Next- install connectors into the 4 corner posts at the top of the slide rod. Be sure the holes
in the top of the connector are at a 45 degree angle from the sides of the crib as shown
below.
If one person is completing this installation- it is helpful to add a support of some kind
across the opposite end of the crib to hold up the other end of the cover as the install is
being completed.
To Next Page
Loading...