Why won't my Hardi Paint Sprayer make enough foam?
If your Hardi Paint Sprayer will not make enough foam, it could be due to a line leak or pinched line, a plugged solenoid valve, a weak foam concentrate mixture, or the water being too hard (consider adding a water softener).
Why don't the foam drops last from my Hardi Paint Sprayer?
If the foam drops from your Hardi Paint Sprayer do not last, it could be due to not enough foam concentrate, the frequency valve not being opened enough, weak foam concentrate, or the water being too hard (consider adding a water softener).
Why does my Hardi Paint Sprayer keep blowing fuses?
If your Hardi Paint Sprayer keeps blowing fuses, it could be due to a short in the electrical system, a bad compressor, a bad relay on the printboard, or a plugged tank filter.
Why won't the system flush (pump, control, and boom) on my Hardi Paint Sprayer?
If the system on your Hardi Paint Sprayer will not flush (pump, control, and boom), it could be due to the Suction Manifold valve not being in the correct position, or the PTO not being engaged.
General| Brand | Hardi |
|---|---|
| Model | MEGA 230 |
| Category | Paint Sprayer |
| Language | English |
To Next Page