EasyManua.ls Logo

Harley M6 - EQUIPMENT SAFETY PRECAUTIONS; MAINTENANCE SAFETY; DUST EXPOSURE PRECAUTIONS

Harley M6
50 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MODEL M6 9
EXPOSURE TO RESPIRABLE CRYSTALLINE SILICA DUST ALONG WITH
OTHER HAZARDOUS DUSTS MAY CAUSE SERIOUS OR FATAL
RESPIRATORY DISEASE.
It is recommended to use dust suppression, dust collection and if
necessary personal protective equipment during the operation of any
attachment that may cause high levels of dust.
WARNING
WATCH FOR OPERATING HAZARDS
Look down and to the rear and make sure area is clear before operating in
reverse.
Watch for hidden hazards on the terrain during operation.
Use extreme care when working close to fences, ditches, other obstructions,
or on hillsides.
Reduce ground speed on slopes and rough terrain.
Do not operate on steep slopes.
Do not stop, start, or change directions suddenly on slopes.
Stop skid-steer and implement immediately upon striking an obstruction.
Dismount skid-steer using proper procedure. Inspect and repair any dam-
age before resuming operation.
MAINTENANCE SAFETY
Your dealer can supply original equipment hydraulic accessories and repair
parts. Substitute parts may not meet original equipment specications and
may be dangerous.
Avoid electrical system hazards. Never work on the electrical system
unless you are qualied and thoroughly familiar with system details and
the special handling requirements.
Disconnect battery before working on electrical system. Remove “ground”
cable rst. When reconnecting battery, connect “ground” cable last.
Never perform service or maintenance with engine running.
Tighten all bolts, nuts, and screws, and check that all cotter pins are in-
stalled securely to ensure equipment is in a safe condition before operating.
WARNING
WARNING

Table of Contents