4 MODEL M6
BOLT TORQUE CHART
After every ten (10) hours of operation, check all hardware and tighten where required.
SAE Series Torque Chart
DO NOT use these values if a different torque value or tightening procedure is listed for a specic
application. Torque values listed are for general use only.
Fasteners should be replaced with the same grade.
Make sure fastener threads are clean and you properly start thread engagement. This will
prevent them from failing when tightening.
Metric Series Torque Chart
Use only metric tools on metric hardware. Other tools may not t properly. They may slip and
cause injury.
To Next Page
Loading...