6 MODEL M6
PROTECT AGAINST FLYING DEBRIS
Always wear proper safety glasses, goggles, or a face shield when driving
pins in or out or when any operation causes dust, ying debris, or any other
hazardous material.
LOWER OR SUPPORT RAISED EQUIPMENT
Do not work under raised booms without supporting them. Do not use
support material made of concrete blocks, logs, buckets, barrels, or any other
material that could suddenly collapse or shift positions. Make sure support
material is solid, not decayed, warped, twisted, or tapered. Lower booms to
ground level or onto blocks. Lower booms and attachments to the ground
before leaving the cab or operator’s station.
USE CARE WITH HYDRAULIC FLUID PRESSURE
Hydraulic uid pressure can penetrate the skin and cause serious injury or
death. Hydraulic leaks under pressure may not be visible. Before connecting
or disconnecting hydraulic hoses, read your prime movers operator’s manual
for detailed instructions on connecting and disconnecting hydraulic hoses or
ttings.
Keep unprotected body parts, such as face, eyes, and arms as far away as
possible from a suspected leak. Flesh injected with hydraulic uid may
develop gangrene or other permanent disabilities.
If injured by injected uid, see a doctor at once. If your doctor is not
familiar with this type of injury, ask him to research immediately to
determine proper treatment.
Wear safety glasses, protective clothing, and use a sound piece of card
board or wood when searching for hydraulic leaks. DO NOT USE YOUR
HANDS! SEE ILLUSTRATION BELOW.
DO NOT MODIFY MACHINE OR ATTACHMENTS
Modications may weaken the integrity of the attachment and may impair the
function, safety, life, and performance of the attachment. When making
repairs, use only the manufacturer’s genuine parts, following authorized
instructions. Other parts may be substandard in t and quality. Never modify
any ROPS (Roll Over Protection System) equipment or device. Any
modications must be authorized in writing by the manufacturer.
To Next Page
Loading...