Vi1000 USER MANUAL
16.2.1 16.2.1 MENU > SHOWS > DATA
16.2.1 MENU > SHOWS > DATA
Menu: Shows - Recorded Data
Some settings are recorded as part of a Show, others as part of a Snapshot, and a few are not recorded at all.
Please note that in addition to the snapshots in the cue list, a Show has one ‘Show Snapshot’. This Show Snapshot
is generated automatically, and it cannot be seen by the user. It holds the Cue List, the Show Settings and Audio
Settings. These three sets of data contain all of the parameters that change when a Show is loaded.
The Show Snapshot’s Audio Settings contains all the settings which a standard Snapshot can store; as a result, the
Show Snapshot can be thought of as the last settings before the Show was unloaded (Assuming you choose to save
the existing show before loading a new one). The Show Snapshot allows the complete status of the console to be
recorded with the Show, even if no Snapshots have been saved.
Settings Recorded Within A Show Snapshot’s Show Settings.
• Monitoring Settings: Monitor Level; Phones Volume; Solo Trims; Solo Blend; Monitor A/B Switch Status; Monitor On/
Off Switch Status; Monitor Source Selection Status; Monitor Setup states.
• All switches in Talkback section.
• Talkback Settings: Talkback Levels; Talkback setup.
• Generator Settings: OSC Level, Type.
• Mute Safe Status (Input & Output).
• System Preferences: Current Sample Rate, Dante/MADI source switch, Dante clock mode.
• Automation Setup States.
• VCA / MG Assign View switches status: Currently selected view.
• Bus Cong States: Bus Formats; Bus Types and Bus Labels.
• Channel Pairing States: Stereo Channel pairings.
• HiQnet Setup.
• MIDI Conguration Setup: MIDI Channel names.
• ISO switch status (Input & Output).
• O/P Vistonics Lock Mtr switch status.
• O/P Vistonics Solo/OnOff/TB switches.
• All parameters in the Menu/Settings page.
• Follow Solo switches.
Menu: Shows - Show File Recorded Data
To Next Page
Loading...
