Harman Soundcraft Vi1000 - 1: MON Setup; Source Select

Vi1000 USER MANUAL
10.2 10.2: MONITORING > SETUP
10.2: MONITORING > SETUP
Solo-In-Place
Mode
Activate the SOLO-IN-
PLACE mode.
This is a destructive mode for use only during
soundchecks or rehearsals. When a channel is soloed
in SIP mode, all other channels are muted so that only
the soloed channel is heard, in its stereo position, at the
console’s mix outputs.
Mute Safe
Mode
Enable the Mute
Safe (SIP isolation)
conguration mode.
If (MUTE SAFE) is active the Mute safe state from the
Input channels can be toggled with the Channel’s SEL
Key. The state for a given channel is indicated by that
channel’s Mute Safe LED. NOTE: This conguration
mode is disabled when the setup page is exited.
MON SETUP
Mode
Activate the Monitor
Setup sub-page.
The Monitor Setup sub-page parameters become
available in the VST area of the master screen. See
below for more details.
Auto Cancel
Mode
Activates Autocancel
mode for all solos.
When Autocancel is active, each new solo cancels the
the currently active one. When not active, solos can be
added, and the audio is summed.
LCR Source
Select
Select the mix master
output sources for the
monitor outputs A, B,
and HP
For the Monitor A (LCR) output you can choose LCR
and/or C; for the Monitor B and Headphone outputs
you can choose LR and/or C. This selection cannot be
combined with the User A or User B sources, but solo
and talkback options are concurrent.
User A / B
Source Select
Select the user-dened
output source for the
monitor outputs A, B
and HP.
Choose EITHER User A or User B as a main source
for the monitoring output. This selection cannot be
combined with the LCR, LR, or C sources, but solo and
talkback options are concurrent. Each of the monitoring
outputs has its own individual USER A / B assignment.