Harman Soundcraft Vi1000 - Page 67

6.5.5 6.5.5: INPUT CHANNEL > OUTS (PAN, INSERT, DIR, DELAY)
Vi1000 USER MANUAL
6.5.5: INPUT CHANNEL > OUTS
Insert Trim Field / Group: TRIM Range Low Range High
Adjust the actual send
signal level.
Insert On Field / Group: TRIM Inactive Active
Activate the insert point. Off On
Direct Output
On
Field / Group: Inactive Active
Activate the Direct
Output for this input
channel.
Off On
Direct Output
Gain Field / Group: Range Low Range High
Adjust the gain of the
channel's Direct Output.
-90dB +10dB
Direct Output
Point
Field / Group:
Select the point in the
input channel's signal
path for the Direct
Output 'tap'.
Options are pre HPF, post-HPF/Pre-processing,
post-processing/pre-fader, or post-fader.
Direct Output
Patch
Field / Group: DIRECT
OUT Inactive Active
Select and assign
physical I/O for the
direct output.
Opens a patching screen in the corresponding Vistonics
touch screen area.
Close Patch
Screen
Open Patch
Screen