Harmony COMMANDER - Installing with 3-Point Lap-and-Shoulder Vehicle Seat Belt System

5. Should you need to loosen the UAS,
push the UAS release buon ❺.
! WARNING: NEVER put two UAS
connectors on one vehicle UAS
anchor unless specically allowed
by the manufacturer ❻.
6. Secure the top of the child
restraint using the top tether
strap (see “Using Top Tether”).
! Conduct a safety check for a secure
installaon (see “Installaon safety
check”). Perform this test every
me you drive with your child and
whenever you readjust the child
restraint as your child grows.
27

SHOULDER VEHICLE SEAT BELT SYSTEM


If a UAS installaon is not an opon,
then use the following belt-only
installaon method.
! WARNING: UAS must be stored
when using the vehicle belt. Clip
both UAS hooks to the fabric loops
on each side of the backrest ❶.
1. Place the child restraint
ush against the back of
a forward-facing vehicle
seat.
2. Thread the vehicle
seat belt through the
belt slot opening and
out the other side. See
illustraons for proper
roung path of Lap-and-
Shoulder Belt ❷.

