Harmony COMMANDER - Installation Safety Check

Your vehicle’s Top Tether
Anchor Points may be idened
using one of these symbols:
• Check that the Top Tether is securely aached to the
child restraint.
• Fasten Top Tether clip to anchor point ensuring the clip
is facing downwards and the strap is not twisted ❶.
• With the child restraint installed with the UAS or
vehicle seat belt, ghten the Top Tether strap securely
by pulling on the free end of the Top Tether strap ❷.
• To loosen, press the Top Tether release buon ❸.
! WARNING: Ensure that Top Tether strap is NOT
twisted.
29
INSTALLATION SAFETY CHECK
Perform this test EVERY TIME you
drive with your child and whenever
you readjust the child restraint as
your child grows:
Rock the child restraint back and
forth and side to side to make sure
the UAS or vehicle seat belt does
not lengthen or loosen, and the child restraint does not
move easily ❶.
The back of the child restraint (connecon point) should
not move more than 2.5 cm (1 inch) in any direcon.

❶
❷
❸