Harmony COMMANDER - Installation - Booster Without Backrest

39
just touching their thighs and is NOT across their
stomach.
6. Buckle the vehicle seat belt into place and ensure it is
secure by gently pulling on it.
! BOTH SIDES OF THE LAP BELT MUST PASS UNDER
BOTH ARMRESTS, AND THE LOWER END OF THE
SHOULDER BELT MUST PASS UNDER THE ARMREST
ON THE BUCKLE SIDE.
! Any straps holding the restraint to the vehicle should
be ght, any straps restraining the child should be
adjusted to the child’s body, and all straps should not
be twisted.
! NEVER USE A VEHICLE LAP-ONLY BELT WHEN USING
THIS BOOSTER SEAT.
! WARNING: To avoid possible entanglement hazard,
see “Entanglement with vehicle seat belt”.

See “Assembling/disassembling child restraint” for
instrucons for removing the backrest.
1. Place the booster seat ush against a forward-facing
vehicle seat. The vehicle seat MUST be equipped with
a 3-point lap-and-shoulder belt. Booster must be
level, stable and not rock side-to-side (see “Vehicle
seang posions”).
2. Place child on the booster seat with child’s back at
against the vehicle seat.
3. Thread both sides of the lap belt
under BOTH armrests. Thread
the lower end of the
shoulder belt under
the armrest on the
buckle side ❶.
ENSURE that the belt is
snug across the child’s
hips. It is important to ensure that any lap strap is
❷
