40
just touching their thighs and is NOT across their
stomach.
4. Buckle the vehicle seat belt into place and ensure it is
secure by gently pulling on it.
! BOTH SIDES OF THE LAP BELT MUST PASS UNDER
BOTH ARMRESTS, AND THE LOWER END OF THE
SHOULDER BELT MUST PASS UNDER THE ARMREST
ON THE BUCKLE SIDE.
! Any straps holding the restraint to the vehicle should
be ght, any straps restraining the child should be
adjusted to the child’s body, and all straps should not
be twisted.
! NEVER USE A VEHICLE LAP-ONLY BELT WHEN USING
THIS BOOSTER SEAT.
! WARNING: To avoid possible entanglement hazard,
see “Entanglement with vehicle seat belt”.
! THE VEHICLE’S SHOULDER BELT MUST LIE ACROSS
THE CHILD’S SHOULDER AND LAY ACROSS THE
CHEST – NOT THE FACE OR NECK. If the belt does not
lie properly across the child’s shoulder and chest, the
RED shoulder belt safety guide (“Parts list - T”) MUST be
used to ensure proper placement (see “Using shoulder
belt safety guide”).
TO INSTALL:
1. Insert loop end of strap
around bar on rear of seat
❶ on side OPPOSITE to
the vehicle retractor.
2. Pass the red clip and strap
through the loop end ❷
and pull strap ght ❸.
It is recommended to store the unused
shoulder belt safety guide along with any
other parts from the booster seat for
future use.
INSTALLING/REMOVING SHOULDER BELT
SAFETY GUIDE
To Next Page
Loading...
