Harmony DEFENDER 360 - INSTALLING WITH LATCH OR VEHICLE SEAT BELT

Pass the 8.8 inch
(22.3 cm) connector
rod through assembly.
Insert the washer and
0.5 inch (1.2 cm) screw
on opposite side and
ghten ❹.
: If connector rod does not pass through easily, make
sure it is aligned with holes and tap screw head
lightly to guide it through the plasc.

 

❹








You can install the child restraint using  the
LATCH or vehicle seat belt.
: The ower nchors and ethers for ildren
(LATCH) is used for installing the child restraint 
using the vehicle seat belts.
The LATCH can  be used if your vehicle has the
LATCH anchors installed and designated LATCH seang
posions. Check your vehicle owner’s manual to see
which seang posions may be equipped with LATCH.
: If LATCH is not an opon, you 
use the vehicle’s lap-only or lap-and-shoulder belt to
install the child restraint in your vehicle.
22