shoulder seat belt (see “Installing with Lap-and-
Shoulder or Lap-Only belt system”, pg. 32).
• Once seat belt is aached and properly adjusted, grasp
the two straps (lap and shoulder) together as close to
the vehicle belt buckle plate as possible. Unbuckle the
belt without allowing it to slip.
• Aach the locking clip around both lap and shoulder
belts ❶.
• Posion the locking clip about
1 inch (2.5 cm) from vehicle belt’s
buckle plate.
• Rebuckle belt. Check that the lap
belt does not move by pulling hard.
If belt loosens or lengthens, repeat
the procedure.
Test installaon to see if child restraint is secure. The
child restraint should be able to move in any
direcon where is connects to the vehicle. If the child
restraint can be moved more than 1 inch (2.5 cm) in any
direcon at the connecon point, then unbuckle the
seat completely and repeat the steps above unl secure
(see “Installaon safety check”, pg. 34). If you have any
quesons, please contact Harmony Juvenile Products
customer service.
Store locking clip when not in use.
use locking clip in booster mode.
1” (2.5 cm)
❶
25
To Next Page
Loading...
